CNC lathe processing environment turning and milling compound

What are the requirements for the working environment of turning milling compound CNC lathe

Turning milling compound CNC lathe as a precision mechanical equipment, if not placed in a reasonable environment, it is very easy to damage the body, so it is necessary to strictly control the site and use requirements of the machining center, specific reference can be made to the following points.

Generally, the machining center is installed in the machining workshop, which not only changes the environment temperature greatly, but also has many kinds of mechanical and electrical equipment, which makes the power grid fluctuate greatly. Therefore, the installation position of turn milling CNC lathe requires strict control of power supply voltage. The power supply voltage fluctuation must be within the allowable range and keep relatively stable. Otherwise, it will affect the normal work of CNC system of turn milling compound CNC lathe.

The ambient temperature of turning milling CNC lathe is lower than 30 diopter and the relative temperature is less than 80%. Generally speaking, there are exhaust fans or air coolers inside the numerical control cabinet to keep the working temperature of electronic components, especially the CPU, constant or small temperature difference. High temperature and humidity will reduce the life of control system components and increase the failure. With the increase of temperature and humidity, more dust will be produced on the integrated circuit board and cause short circuit.

When the user is using the turning milling compound numerical control lathe, it is not allowed to change the parameters set by the manufacturer in the control system at will. The parameter setting of these turning milling CNC lathes is directly related to the dynamic characteristics of each part of the lathe. Only the gap compensation parameters can be adjusted according to the actual situation.

Turn milling CNC lathe should be far away from the vibration source, avoid direct sunlight and thermal radiation, and avoid the influence of moisture and air flow. If there is a vibration source near the turning milling CNC lathe, the anti vibration groove should be installed around the turning milling CNC lathe. Otherwise, it will directly affect the machining accuracy and stability of turn milling CNC lathe, which will lead to poor contact of electronic components, cause failure and affect the reliability of turn milling CNC lathe.