Gas Assisted Injection Booster

Specially designed for gas-assisted injection molding system, the common pressure is 35MPa, up to 250MPa;


The high pressure part is isolated from the outside, so it does not pollute the air source during the pressurization process, ensuring the quality of the high pressure air source;


High precision filtration, can filter out the influence of the injection molding quality of impurities;


The system contains high voltage regulator and high pressure storage tank to ensure stable output of high pressure gas pressure and flow rate;


Multilevel safety measures, overpressure automatic relief;


Automatic control, low pressure does not start, automatic stop after pressure.


20200731102042.jpg