How to clean the filter element of oil filter?
It is very important for us to clean the oil filter in the process of use. The oil filter element is used to keep the hydraulic oil clean in the oil filter. How to ensure the cleanliness of the oil filter element for a long time depends on our correct use! First of all, we should correctly choose the filter element of the oil filter, because the model between the filter element and the equipment is matching, if not properly selected will affect the filtering effect.
Second, the filter element of the oil filter needs to be cleaned and replaced in a timely manner, because the impurities in the oil are all gathered on the top of the filter element during the cleaning of the oil. A long period of unclarity will cause the oil filter speed to slow down and the oil quality is not clean enough.
Third: the axial pressure cannot be increased in the process of use. If so, the oil can pass through the filter screen quickly, but it will often crush the filter element, affecting the cleanliness of the hydraulic oil.
In order to ensure that the filter element of the oil filter is clean, we must timely clean the filter element of the oil filter. The method is described as follows:
1. Before cleaning the oil filter, it is necessary to stop the operation of the oil filter, close the oil inlet and outlet pipelines, and turn off the power switch.
2. Open the oil valve and drain all the oil in the filter until the oil runs out (open the air valve during oil discharge to speed up oil discharge).
3. Open the filter cover and take out the filter element after putting.
4. Take out the filter element of the vacuum oil filter and put it into an oil pan filled with kerosene. Soak for 30 minutes, then clean it and blow it clean with air.
5. Remove the sediment on the surface of the filter with a brush, and then wipe the filter clean with a rag.
6. Then install the filter element and lock the filter bolt. Only after cleaning can it be put into use.
On 2018-08-08 11:45:46
