Vacuum oil filter system

The basic requirements of the oil transfer system of the vacuum oil filter machine are as follows: manual turning, no jamming phenomenon, no oil leakage during operation, and the technical indexes meet the national standard. The oil pump is precision machined with unique seal to ensure no leakage. Even in the system at the limit of the vacuum pump oil is normal, to ensure the stability of the performance of the machine, improve the efficiency of oil treatment. Vacuum separation system of vacuum oil filter. Vacuum filter oil machine adopts vacuum negative pressure principle of compound 3 d vacuum separator greatly increase the vacuum separation area, oil mist in the vacuum separator through film sprayer, spray device to spray, thin film, gasification process, the oil and water molecules in the vacuum system completely, make the moisture in the oil and gas get enough vaporization separation time, to be able to adequately removal from water and gas. Condensing system, unique medium condensing system completely cools the water vapor separated from the oil, prevents the water vapor from entering the vacuum pump, causes the vacuum pump oil emulsification and injection, and extends the service life of the vacuum pump.

In the heating system of vacuum oil filter, the heating surface heat load is lower than 1.0W/ CMM. During the heating process, there will be no harm caused by the cracking and aging of superheated oil. The heating system is safe and reliable. It is equipped with safety protection device to prevent dry burning without oil in the heating system. The heating system is interlocked with the vacuum system and the oil discharge system to avoid damage to the equipment caused by excessive oil temperature. Use interval control, avoid oil temperature to reach the set temperature contactor start frequently, greatly extend the service life of the electrical appliances. The optimized heating device design effectively eliminates the generation of harmful gases in the process of oil filtration, and forms a safe and reliable heating system. The pipeline design ensures that there is no "dead oil zone", and the oil temperature can be arbitrarily adjusted between 20 ℃ and 80℃ for constant temperature heating. At the same time, depending on the climate, there are automatic and manual heating options.

Vacuum oil filter control system, with over pressure, over flow, overload protection device. Vacuum pump, oil pump and heater are designed to prevent dry burning of heater and idling of oil pump. Intelligent display temperature controller is selected, which is characterized by high reliability and can set the upper and lower limits of temperature to avoid escape. Frequent starting of heater can extend the service life of electric appliances.