CNC Internal Grinder in the grinder, presumably we are not unfamiliar with it, because in front of it, there is relevant knowledge in this respect, so that we can understand this kind of grinder. However, because it contains a lot of content, it will be carried out step by step, so that we can have a good learning effect, and this is beneficial and harmless to us.
1.There are mainly CNC grinding on the end face? In addition, what problems can be solved by this method?
CNC Internal Grinder, if it is used to grind small end face, it mainly includes gear bore, Morse taper hole on grinder head and tail frame spindle, bearing bore and milling machine spindle 7 / 24 taper hole. Using this kind of grinder, we can solve some operation technical difficulties of internal grinder, and get good grinding effect.
2. What is the taper of CNC Internal Grinder? And why does it crawl?
The taper in CNC Internal Grinder, specifically speaking, refers to the ratio between the cone bottom diameter and the cone height. If the grinder is a cone, then it refers to the ratio between the diameter difference between the upper and lower bottom circles and the height of the cone. Therefore, it should be determined according to the specific situation.
3. What are the reasons for crawling of CNC Internal Grinder? And, if there is no inner hole grinder, can CNC Internal Grinder be used for grinding?
If the CNC Internal Grinder crawls, then, in terms of specific reasons, it may be due to poor lubrication, or the grinding machine walking speed is too slow. As for the second question, the answer is yes, and in some aspects or occasions, it can be done without any problems.
4. How to measure parts on CNC Internal Grinder?
Generally speaking, the diameter value of CNC internal grinder is measured directly. In addition, in order to facilitate measurement and programming, the coordinate value in X direction is programmed by diameter value, while the coordinate value in Z direction is programmed by half radius value.
On 2018-08-08 11:45:46
