In the process of grinding wheel correction, cylindrical grinder can effectively select the appropriate amount of correction according to its grinding requirements. The fixture of cylindrical grinder needs to clean the center hole at both ends of the workpiece in the process of operation. If there is burr or flash in the center hole of the product, triangular scraper can be used to remove it.
Cylindrical grinder in the use of the process can effectively adjust the position of the head frame and tail frame, so that the distance between the equipment and the length of the workpiece can be adapted, so that the workpiece can be effectively located in the middle of the worktable, the equipment in the center hole to add its lubricating oil or grease.
Cylindrical grinder can effectively use the hand to rotate the workpiece. During operation, the spring pressure of the top of the equipment can be adjusted appropriately according to the rotation tightness, so that the tightness can be appropriate.
In the process of operation, the cylindrical grinder can effectively select the appropriate workpiece operation according to the speed of the grinding wheel and the processing requirements of the workpiece materials. The whole equipment can obtain the required speed by adjusting the head frame speed change mechanism.
The cylindrical grinder measures the size of the workpiece, so as to determine the grinding allowance. The equipment should check the radial runout of the long workpiece with large quenching deformation. If the runout is too large, it needs to be ground after straightening.
Cylindrical grinder has a wide range of applications, products in use can effectively process a variety of cylindrical conical outer surface and shaft shoulder end grinder, can grind the inner and outer conical surface with larger inner hole taper. But the degree of automation of the equipment is relatively low, which is only suitable for small batch single piece production.
On 2018-08-08 11:45:46
