high temperature furnace structure and performance

Purpose and performance of high temperature furnace

1, high temperature drying furnace, high temperature is 450 degrees, using digital temperature control instrument as automatic temperature control constant temperature, widely replace the original pointer temperature controller.

2, using digital display temperature control instrument control its advantages: clear and eye-catching reading, digital display sensitive and accurate, reliable performance, easy to operate.

3. This type of high temperature drying furnace is suitable for baking, drying, heat treatment and other heating in workshops or experiments of industry and agriculture, medical and health, universities and scientific research departments.

4. The box is equipped with a blast circulation device to facilitate the hot air convection in the studio and make the temperature in the studio more even.

5, this product belongs to the ordinary electric heating blast high temperature drying furnace, if you need to handle precise valuables, please choose other products of our factory.

high temperature furnace structure

1. The shell of this type of high temperature drying furnace is made of cold-rolled steel plate box Angle steel bent and welded. The surface is covered with high temperature resistant baking paint. Glass fiber is filled between the shell and inner Dan to form a reliable insulation layer. One heater or two heaters are respectively installed at the bottom of the studio. The first heater is managed by the heating switch, while the second heater is directly controlled by the instrument.

2. The interlayer of the box door is stuffed with glass fiber for heat preservation. Sealing strips are embedded in the slot around the door to ensure the sealing of the door and the box body and prevent heat leakage in the box.

3. There are shelf supports on both sides of the studio, which are equipped with shelf nets for placing test products. The lower part of the studio is a pull-out punching heat sink. The heat sink is equipped with an electric heating wire plate, a blast impeller and an air inlet hole.

4. The top of the box is equipped with an exhaust valve, which can be changed by rotating the outer surface of the valve body to leave its size. Inside the left side door of the box body is an electrical control box. The upper part of the box is equipped with a control instrument sensor, the middle part is an electrical control part, and the lower part is the outlet line of the blast motor and electric heating plate.