Selection principle of grinding wheel diameter of internal grinder and how to align workpiece
In many kinds of grinder, the internal grinder is not only a website product but also a website keyword. Therefore, for us, it is a key learning object, and we should not be careless in learning attitude. So, based on this, next, we might as well continue on the basis of the previous, so that we can have new learning content, and then speed up the learning speed of the product.
1. What is the processing range of internal grinder? And, what is the selection principle of its grinding wheel diameter?
Internal grinder this kind of grinder, it has a certain range of processing, if summarized, then, mainly for: cylindrical, conical grinding, as well as some other shapes or lines into the inner hole surface and end processing. As for the selection principle of grinding wheel diameter, it is greater than half of the aperture or less than two-thirds of the aperture.
2. How to adjust the step hole in internal grinder?
To adjust the step hole of internal grinder, the specific operation is as follows: first, turn off the starting power switch in the equipment, and shake the position of workpiece and grinding wheel on the worktable through the locking screw on the limit stop. Then, adjust the limit block to the reversing switch position and lock the block. After that, check whether the grinder stroke needs to be adjusted, if necessary, it should be carried out in time. When everything is OK, turn on the power switch.
3. How to align the workpiece on the internal grinder?
On the internal grinder, the work of aligning the workpiece is as follows:
Workpiece alignment can be carried out with the help of magnetic gauge base and dial indicator head. First, roughly align the working position, then touch the contact of the dial indicator to the inner hole of the workpiece, and slowly move the chuck to find the accurate position. The specific amount depends on the deviation.
On 2018-08-08 11:45:46
