powder coating and spray painting use burn off oven

Introduction:

The hot cleaning furnace can efficiently and safely wash the chemicals attached to metal parts such as coating nozzles.Use of polymer is higher than 300 degrees was isolated from the air can be cracking, above 400 degrees in a small amount of air can completely oxidation characteristics, first with polymer sewage workpiece heated to 400 degrees (proposed) according to the technical requirement, make the workpiece on the number of polymer melt flowing to a collection container at the bottom of the furnace, and then the temperature rises to 400 degrees, and ventilation with a small amount of fresh air, make the rest of the polymer oxidative, generates carbon dioxide, after water spray with pump, water ring type with water from outside.

By thermal cleaning to remove surface coating and paint of the hanging work pieces,they are placed in the main decomposition chamber at ambient workpieces temperature from 250 ~ 420 ℃ to removal of organic matter on the workpiece. After the process, the surface of work piece is without any organic coating layer residual.

Application:

1. Remove the thickening coating on the spray hanger and fixture without changing the mechanical properties of the hanger.

2. Completely and completely peel off the unqualified paint or powder coating on the surface of steel parts and aluminum parts without damage to the workpiece.

3, clear water curtain spray cabinet filter, fan impeller adhesion paint layer.

4. Clean and remove the winding and adhesion of wires, cables, transformers, motors and printing rollers.

5. Clean and remove grease, oil and other organic matter on engine, crankshaft, box body, piston ring and other parts.